Analytical modeling of complex contact behavior between rock mass and lining structure

Based on the nondestructive test data of operating railway tunnels in China, this paper summarizes the basic characteristics of the complex contact behavior between the rock mass and lining structure. The contact modes are classified into dense contact, local non-contact, and loose contact. Subsequently, the corresponding mechanical model for each contact mode is developed according to its mechanical characteristics using the complex variable method. In the proposed mechanical model, a special algorithm is introduced to detect whether the local non-contact zone is re-contacted. Besides, a novel conformal mapping method is also proposed to accurately calculate the mechanical response of the concrete lining. Finally, the accuracy of the proposed method is verified by comparing it with the finite element method (FEM). Several parameter investigations are conducted to analyze the effects of different contact modes on the rock–lining interaction. The results show that: (i) the height of the local non-contact area does not have a significant effect on the contact stress distribution if no re-contact occurs; (ii) backfill grouting can reduce the local stress concentration caused by poor contact modes; and (iii) reducing the friction coefficient of the interface can lead to a more uniform distribution of internal forces in the concrete lining.     

基于K-means和SOM的水下传感器数据采集方法

随着海洋资源勘探和海洋污染物监控工作的开展，水文数据的监测和采集等已经成为重要的研究方向。其中，水下无线传感器网络在水文数据采集过程中起着举足轻重的作用。本文研究的是水下无线传感器二维监测网络模型中，传感器节点数据采集的问题，其设计方法是通过自组织映射（Self-organizing mapping，SOM）对传感器节点进行路径最优化处理，结合优化的路径图形和K-means算法找到路径内部聚合点，利用聚合点和传感器的节点得到传感器通信半径内的数据采集点，最后通过SOM得到水下机器人（Autonomous underwater vehicle，AUV）到各个数据采集点采集数据的最优路径。经过实验验证，在水下1 200 m×1 750 m范围内布置52个传感器节点的情景下，数据采集点相比于传感器节点路径规划采用相同的采集顺序得到的路径优化了6.7%；对数据采集点重新进行自组织路径规划得到的路径比传感器结点路径的最优解提高了12.2%。增加传感器节点的数量，其结果也大致相同，因此采用该方法可以提高水下机器人采集数据的效率。     

小微数据包高效无线传输技术的发展和趋势

5G-NR和B5G系统都需能高效地支持小微数据包(块)的传输,且在不同的无线传输技术(如宽带或超低时延)之间快速灵活地切换。系统梳理和比较和小微数据包(块)相关的多种无线传输技术,如两步RACH、预配置授权和公共资源竞争等,分析它们对3GPP各个系统和各个RAN协议的影响和复杂度优劣等,并进一步展望其未来发展和应用趋势。     

A novel fabrication procedure for producing high strength hydroxyapatite ceramic scaffolds with high porosity

Hydroxyapatite (HA) scaffolds were fabricated using the space holder method with a pressureless sintering process in a systematically developed manner at different fabrication stages to increase the strength of the scaffold at high porosity. Polyvinyl alcohol (PVA) and Polymethyl methacrylate (PMMA) were used as binders and space holder agents, respectively. The physical properties of the HA scaffolds were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), linear shrinkage test, and porosity measurements. The mechanical properties of the HA scaffolds were analyzed using compressive strength measurements. The results revealed that the HA scaffold met the expected quality requirements with a compressive strength of 2.2 MPa at a porosity of 65.6% with pore sizes distributed in the range of 126–385 μm. The shrinkage of the scaffold diameter occurred by 20.27%, this diameter shrinkage predominantly to the shrinkage of the HA scaffold caused by sintering. Besides, suspect that a higher PMMA concentration causes pore size shrinkage upon sintering. The formation of pore interconnections was evidenced by SEM observations and the ‘translucent light method’ developed in this study. The results of the scaffold phase test using XRD showed that the final scaffold consisted only of the HA phase, as the PVA and PMMA phases burned out during the sintering process.     

基于秩序与非秩序理论的文创产品卡通形象设计研究

目的 从秩序与非秩序理论出发,研究文创产品卡通形象的设计方法.方法 对秩序与非秩序理论的视觉机制和创制理论进行梳理,结合实例,阐述了其与文创产品卡通形象设计之间的联系,分析文创产品卡通形象中的秩序与非秩序的表现形式,提出基于秩序与非秩序理论文创产品卡通形象设计的主要原则,归纳出一套基于秩序与非秩序理论的文创产品卡通形象设计流程与方法,指导设计实践,并验证这些理论方法在设计实践中有效性与可行性.结论 通过对秩序与非秩序理论的研究,文创产品卡通形象设计时应注意提高辨识度、亲和力和便于衍生设计的原则.探索基于秩序与非秩序理论的设计流程与方法,按照界定主题、主体形象设计、主体形象拓展、衍生品应用四个环节开展整体方案设计,为文创产品卡通形象设计提供新的思路与方法.     

基于魅力工学的传统器物设计评价应用研究

目的 在传统器物的创新设计中,最重要的环节是了解消费者对所使用产品的不同感受与意向并转换为具体的设计要素.研究消费者心理的感性因素与传统器物设计元素之间的联系,确定设计要素,从而对产品进行创新设计,为提升传统器物附加值作出贡献.方法 以中国传统器物茶宠为例,首先对8位相关的茶宠专家进行访谈,通过魅力工学中的评价构造法整理并提取魅力因子,设计出问卷调查表;然后以访谈内容为依据,使用问卷调查法得到大众对茶宠的魅力评价,共回收84份有效问卷;最后应用数量化一类分析茶宠魅力因子影响权重.结果 得到了数量化一类统计表,选取了其中影响因素较大的魅力因子作为茶宠设计前的风格定调考量.结论 通过茶宠的研究案例证明了该理论的可行性,为未来传统器物的设计提供了更多元且新颖的设计依据.     

Benchmark experiment of large-angle scattering reaction cross section of iron at 14 MeV using two shadow bars – Comparison of experimental results with ENDF/B-VIII –

ABSTRACT

It is important to perform neutron transport simulations with accurate nuclear data in the neutronics design of a fusion reactor. However, absolute values of large-angle scattering cross sections vary among nuclear data libraries even for well-examined nuclide of iron. Benchmark experiments focusing on large-angle scattering cross sections were thus performed to confirm the correctness of nuclear data libraries. The series benchmark experiments were performed at a DT neutron source facility, OKTAVIAN of Osaka University, Japan, by the unique experimental system established by the authors’ group, which can extract only the contribution of large-angle scattering reactions. This system consists of two shadow bars, target plate (iron), and neutron detector (niobium). Two types of shadow bars were used and four irradiations were conducted for one experiment, so that contribution of room-return neutrons was effectively removed and only large-angle scattering neutrons were extracted from the measured four Nb reaction rates. The obtained experimental results were compared with calculations for five nuclear data libraries including JENDL-4.0, JEFF.-3.3, FENDL-3.1, ENDF/B- VII, and recently released ENDF/B-VIII. It was found from the comparison that ENDF/B-VIII showed the best result, though ENDF/B-VII showed overestimation and others are in large underestimation at 14 MeV.     

A comparative study between PVO-based framework and multi-predictor mechanism in reversible data hiding

Sorting-based reversible data hiding (RDH) methods like pixel-value-ordering (PVO) can predict pixel values accurately and achieve an extremely low distortion on the embedded image. However, the excellent performance of these methods was not well explained in previous works, and there are unexploited common points among them. In this paper, we propose a general multi-predictor (GMP) framework to summarize PVO-based RDH methods and explain their high prediction accuracy. Moreover, by utilizing the proposed GMP framework, a more efficient sorting-based RDH method is given as an example to show the generality and applicability of our framework. Comparing with other PVO-based methods, the proposed example method can achieve significant improvement in embedding performance. It is hopeful that more efficient sorting-based RDH algorithms can be designed according to our proposed framework by designing better predictors and their combination methods.     

Simultaneous bioelectricity generation and pollutants removal of sediment microbial fuel cell combined with submerged macrophyte

A submerged macrophyte sediment microbial fuel cell (SP-SMFC) was constructed in this study. Ceratophyllum demersum L., Vallisneria natans, Hydrilla verticillate were chosen as the submerged plants to form cer-SMFC, val-SMFC, hyd-SMFC systems. Plant groups showed the advantage of bioelectricity generation and pollutants removal compared with the unplanted system. The cer-SMFC group stood out with the maximum power density as 24.56 mW m^?2 and the average pollutants removal in overlying water (COD: 81.16%, TN: 65.27%, TP: 79.10%) and in sediments (TN: 26.40%, TP: 21.79%). The determination of root exudates and radial oxygen loss (ROL) demonstrated that C. demersum L. was superior to other studied submerged macrophytes. More root exudates may contribute to an increase in available substrates for electrochemically active bacteria and other microorganisms. Higher enzyme activities were obtained in three SP-SMFCs (especially in cer-SMFC). ATPase and APA activities in cer-SMFC group were increased by over 40% compared with the control. The results indicated that the presence of plants enhanced the microorganism activities, thereby improving bioelectricity generation and pollutants removal. This study will facilitate the application of SP-SMFC technology as an alternative for in situ remediation of polluted sediments.